With thousands trying to cut down on their fuel bills many have turned to a hydrogen on demand fuel cell. Since this technology has become more and more popular all over the world. Being able to increase your gas mileage by as much as 130% is a great thing. Although there are thousands of these kits out on the market today both online and offline. The problem that comes those is these hho dry cell kits normally do not come with maintenance instructions. So here is a little checklist for maintaining your “HHO Dry Cell Water Fuel cell”.

Before we begin we talked to many clients of ours from hhogaskitwizard and the same two questions keep coming up. What happens to the hho dry cell if It runs out of water? How do I maintain my hho dry cell? Both of these popular question among our clients have be answered and we will share those answers with you now.

Maintenance a Hydrogen On demand system is quite easy; that is if every thing is installed correctly. All you really need to do is check the cells water levels, check the cell for leaks as well as the hoses. I was able to take a 750 mile trip and used only a few cups of electrolyte mix.

Making sure the water level in your cell is no less then 1qrt to maintain proper function of your hho dry cell. I have found it is best to check this level at-least every other tank of gas. That is unless your are the type of person that puts $10-20 in your tank every other day to make it a little easier on bills. In that case you should check the water level at-least every 500 miles. You may also want to consider increasing the size of the reservoir to around a 2 or 3qrt. Just in case you do forget to check it. While you took the time to check your water level this would be a good time to do a quick run down and check for leaks. Be sure to check to make sure every thing is tightly fastened as well. Typically the only part of a hho dry cell fuel cell that needs to be replaced is the o-rings, depending on how hot your cell gets is the determining factor to replacing these o-rings. As long as your cell does not get overly heated you should be able to get around 5-10k miles for the o-rings. This all depends on your hho dry cell though. Once you have changed them a few times you should be able to determine the best time to change these.

Oh no you ran your hho dry cell dry:

Cells that run to hot tends to cause what is known as boiling the cell out. This normally only creates a bunch of steam and no actual hho gas causing your cell to blow an o-ring and run it completely dry. The same thing will happen if you forget to keep up on your water levels in your cell. What ever the case may be if the cell runs dry and you installed your hydrogen on demand system correctly, there should be a in line breaker or fuse in place. This is so that when your hho dry cell gets to hot it will trip the breaker of blow the fuse. Which in the long run will save you from having to build another fuel cell. The hho dry cell I personally use has just over 30k miles on it. I am guessing I will need to replace the plates right around 50k miles unless some thing major goes wrong before hand.